LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> G25 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Automatic Drive Positioner System -- G37 Convertible) >> DTC/Circuit Diagnosis >> Sliding Sensor >> Component Function Check

Component Function Check

WARNING: This page is about a different car, the 2011 Infiniti G37. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FUNCTION
    1. Turn ignition switch ON.
    2. Select "SLIDE PULSE" in the "Data monitor" mode using CONSULT-III.
    3. Check sliding sensor signal under the following conditions.
      MONITOR ITEM CONDITION CHART

      Monitor item Condition Valve
      SLIDE PULSE Seat sliding Operate (forward) Change (increase)(1)
      Operate (backward) Change (decrease)(1)
      Release No change(1)
      (1) The value at the seat position attained when the battery is connected is considered to be 32768.

      Is the indication normal? 

      YES: INSPECTION END

      NO: Perform diagnosis procedure. Refer to "DIAGNOSIS PROCEDURE ".

scientia non olet · About LEMON Manuals