Self Diagnosis Result
- In CONSULT-III self-diagnosis, self-diagnosis results and error history are displayed collectively.
- The current malfunction indicates "CRNT". The past malfunction indicates "PAST".
- The timing is displayed as "0" if any of the error codes [U1000], [U1010], [U1300] and [U1310] is detected. The counter increases by 1 if the condition is normal at the next ignition switch ON cycle.
Self-diagnosis Results Display Item
SELF-DIAGNOSIS RESULTS DISPLAY ITEM CHART
| Error item | Description | Possible malfunction factor/Action to take |
|---|---|---|
| CAN COMM CIRCUIT [U1000] | CAN communication malfunction is detected. | Refer to "DIAGNOSIS PROCEDURE ". |
| CONTROL UNIT (CAN) [U1010] | CAN initial diagnosis malfunction is detected. | Replace the AV control unit if the malfunction occurs constantly. Refer to "EXPLODED VIEW ". |
| CONTROL UNIT (AV) [U1310] | AV communication circuit initial diagnosis malfunction is detected. | |
| Cont Unit [U1200] | AV control unit malfunction is detected. | |
| GYRO NO CONN [U1201] | ||
| G-SENSOR NO CONN [U1202] | ||
| CAN CONT [U1216] | ||
| BLUETOOTH MODULE [U1217] | ||
| SUB CPU CONN [U1228] | ||
| iPod CERTIFICATION [U1229] | ||
| Built-in AUDIO CONN [U122E] | ||
| HDD CONN [U1218] | AV control unit malfunction is detected. |
|
| HDD READ [U1219] | ||
| HDD WRITE [U121A] | ||
| HDD COMM [U121B] | ||
| HDD ACCESS [U121C] | ||
| GPS COMM [U1204] | GPS malfunction is detected. | An intermittent error caused by strong radio interference may be detected unless any symptom (GPS reception error, etc.) occurs. Replace the AV control unit if the malfunction occurs constantly. Refer to "EXPLODED VIEW ". |
| GPS ROM [U1205] | ||
| GPS RAM [U1206] | ||
| GPS RTC [U1207] | ||
| USB CONTROLLER [U1225] | USB connection malfunction is detected. | Check that the connection to the USB connector is normal. |
| DSP CONN [U121D] | AV control unit malfunction is detected. |
|
| DSP COMM [U121E] | ||
| DVD COMM [U1227] | AV control unit malfunction is detected. |
|
| CONFIG UNFINISH [U122A] | The writing of configuration data is incomplete. | Write configuration data with CONSULT-III. Refer to "DESCRIPTION ". |
| ST ANGLE SEN CALIB [U1232] | Predictive course line center position adjustment of the steering angle sensor is incomplete. | Adjust the predictive course line center position of the steering angle sensor. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION : SPECIAL REPAIR REQUIREMENT ". |
| FRONT DISP CONN [U1243] | When either one of the following items are detected:
|
|
| GPS ANTENNA CONN [U1244] | GPS antenna connection malfunction is detected. | Check the connection of the GPS antenna connector. |
| XM ANTENNA CONN [U1258] | Satellite radio antenna connection malfunction is detected. | Satellite radio antenna disconnection. |
| USB OVERCURRENT [U1263] | Detection of overcurrent in USB connecter. | Check USB harness between the AV control unit and USB connector. |
| ANTENNA AMP TERMINAL [OPEN or SHORT] [U1264] | Radio antenna amp. ON signal circuit malfunction is detected. | Radio antenna amp. ON signal circuit between AV control unit and antenna amp. |
| AMP ON TERMINAL [GND-SHORT or VB-SHORT] [U1265] | BOSE amp. ON signal circuit malfunction is detected. | BOSE amp. ON signal circuit between AV control unit and BOSE amp. |
|
When either one of the following items are detected:
|
|
|
When either one of the following items are detected:
|
|
|
AV communication circuits between AV control unit and multifunction switch are malfunctioning. | AV communication circuits between AV control unit and multifunction switch. |