LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Brake System) >> On-Vehicle Repair >> Front Disc Brake >> Brake Pad >> Inspection >> Inspection After Installation

Inspection After Installation

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check a drag of front disc brake. If any drag is found, follow the procedure described below.
  2. Remove brake pads.
  3. Press the pistons.
    CAUTION:
    • Never damage the piston boot.
    • When replacing a pad with new one, check a brake fluid level in the reservoir tank because brake fluid returns to master cylinder reservoir tank when pressing piston in.
    NOTE: Use a disc brake piston tool to easily press piston.
  4. Install brake pads.
  5. Depress the brake pedal several times.
  6. Check a drag of front disc brake again. If any drag is found, disassemble the cylinder body. Refer to DISASSEMBLY AND ASSEMBLY 
  7. Burnish contact surfaces after refinishing or replacing brake pads, or if a soft pedal occurs at very low mileage. Refer to INSPECTION AND ADJUSTMENT  .
scientia non olet · About LEMON Manuals