LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 5 (Brake System) >> On-Vehicle Repair >> Front Disc Brake >> Brake Caliper Assembly >> Inspection >> Inspection After Installation

Inspection After Installation

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check a drag of front disc brake. If any drag is found, follow the procedure described below.
  2. Remove brake pads.
  3. Press the pistons.
    CAUTION:
    • Never damage the piston boot.
    • When replacing a pad with new one, check a brake fluid level in the reservoir tank because brake fluid returns to master cylinder reservoir tank when pressing piston in.
    NOTE: Use a disc brake piston tool to easily press piston.
  4. Install brake pads.
  5. Depress the brake pedal several times.
  6. Check a drag of front disc brake again. If any drag is found, disassemble the cylinder body. Refer to DISASSEMBLY AND ASSEMBLY  .
  7. Burnish contact surface between disc rotors and brake pads according after refinishing or replacing disc rotor. Refer to INSPECTION AND ADJUSTMENT  .
scientia non olet · About LEMON Manuals