Values On The Diagnosis Tool
WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-III MONITOR ITEM
MONITOR ITEM STATUS
| Monitor Item | Condition | Value/Status | |
|---|---|---|---|
| MAIN SW | Ignition switch ON | When MAIN switch is pressed | On |
| When MAIN switch is not pressed | Off | ||
| SET/COAST SW | Ignition switch ON | When SET/COAST switch is pressed | On |
| When SET/COAST switch is not pressed | Off | ||
| CANCEL SW | Ignition switch ON | When CANCEL switch is pressed | On |
| When CANCEL switch is not pressed | Off | ||
| RESUME/ACC SW | Ignition switch ON | When RESUME/ACCELERATE switch is pressed | On |
| When RESUME/ACCELERATE switch is not pressed | Off | ||
| DISTANCE SW | Ignition switch ON | When DISTANCE switch is pressed | On |
| When DISTANCE switch is not pressed | Off | ||
| CRUISE OPE | Drive the vehicle and activate the ICC system | ICC system control active | On |
| ICC system control inactive | Off | ||
| BRAKE SW | Ignition switch ON | Brake pedal depressed | Off |
| Brake pedal not depressed | On | ||
| STOP LAMP SW | Ignition switch ON | Brake pedal depressed | On |
| Brake pedal not depressed | Off | ||
| IDLE SW | Engine running | Idling | On |
| Except idling (depress acceleration pedal) | Off | ||
| SET DISTANCE |
|
When set to "LONG" | Long |
| When set to "MIDDLE" | Mid | ||
| When set to "SHORT" | Short | ||
| CRUISE LAMP | Start the engine and press the MAIN switch | ICC system ON (MAIN switch indicator turned on) | On |
| ICC system OFF (MAIN switch indicator turned off) | Off | ||
| OWN VHCL | Start the engine and press the MAIN switch | ICC system ON (Own vehicle detection indicator turned on) | On |
| ICC system OFF (Own vehicle detection indicator turned off) | Off | ||
| VHCL AHEAD |
|
Vehicle ahead detected (Vehicle ahead indicator turned on) | On |
| Vehicle ahead not detected (Vehicle ahead indicator turned off) | Off | ||
| ICC WARNING | Engine running | ICC system malfunctioning (ICC system warning lamp turned on) | On |
| ICC system operating normally (ICC system warning lamp turned off) | Off | ||
| VHCL SPEED SE | While driving | Value of vehicle speed signal (wheel speed) | |
| SET VHCL SPD | While driving | When vehicle speed is set | Displays the set vehicle speed |
| BUZZER O/P | Engine running | When buzzer output signal is outputted | On |
| When buzzer output signal is not outputted | Off | ||
| THRTL SENSOR |
NOTE:
This item is displayed, but cannot monitor
|
0.0 deg | |
| ENGINE RPM | While driving | Equivalent to tachometer reading | |
| WIPER SW | Ignition switch ON | Wiper switch at OFF | Off |
| Wiper switch at LOW | Low | ||
| Wiper switch at HIGH | High | ||
| YAW RATE |
NOTE:
This item is displayed, but cannot monitor
|
0.0 deg/s | |
| STP LMP DRIVE | While driving | ICC brake hold relay activated | On |
| ICC brake hold relay deactivated | Off | ||
| D RANGE SW | Ignition switch ON | When "D", "DS" or "M" range is selected | On |
| When any position other than "D", "DS" or "M" range is selected | Off | ||
| NP RANGE SW | Ignition switch ON | When "N" or "P" range is selected | On |
| When any position other than "N" or "P" range is selected | Off | ||
| PWR SUP MONI | Engine running | Power supply voltage of ICC sensor integrated unit | |
| VHCL SPD AT | While driving | Value of A/T vehicle speed sensor signal | |
| THRTL OPENING | Engine running | Depress accelerator pedal | Displays the throttle position |
| GEAR | While driving | Displays the shift position | |
| CLUTCH SW SIG |
NOTE:
This item is displayed, but cannot monitor
|
Off | |
| NP SW SIG | Ignition switch ON | When any position other than "N" or "P" range is selected | On |
| When any position other than "N" or "P" range is selected | Off | ||
| MODE SIG | Start the engine and press the MAIN switch | When ICC system is deactivated | Off |
| When vehicle-to-vehicle distance control mode is activated | ICC | ||
| When conventional (fixed speed) cruise control mode is activated | ASCD | ||
| SET DISP IND |
|
When SET switch indicator is turned on | On |
| When SET switch indicator is turned off | Off | ||
| DISTANCE | Drive the vehicle in the vehicle-to-vehicle distance control mode | When a vehicle ahead is detected | Displays the distance from the preceding vehicle |
| When no vehicle ahead is detected | 0.0 m | ||
| RELATIVE SPD | Drive the vehicle in the vehicle-to-vehicle distance control mode | When a vehicle ahead is detected | Displays the relative speed |
| When no vehicle ahead is detected | 0.0 m/s | ||