LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2011 >> EX35 Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Automatic Transmission) >> Component Diagnosis >> P1815: Manual Mode Switch >> DTC Logic >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Always drive vehicle at a safe speed.
NOTE: If "DTC CONFIRMATION PROCEDURE" has been previously performed, always turn ignition switch OFF. Then wait at least 10 seconds before performing the next test.
  1. CHECK DTC DETECTION

    With CONSULT-III 

    1. Start the engine.
    2. Select "Data Monitor" mode for "TRANSMISSION".
    3. Drive vehicle and maintain the following conditions for at least 2 consecutive seconds.

      MANU MODE SW : ON 

    Is "P1815 MANU MODE SW/CIRC" detected? 

    YES: Go to "DIAGNOSIS PROCEDURE ".

    NO: Check intermittent incident. Refer to "INTERMITTENT INCIDENT ".

scientia non olet · About LEMON Manuals