Control Units and Electrical Parts: Precautions

WARNING: This page is about a different car, the 2008 Infiniti EX35. However, it is still accessible from the selected car via links, so may be relevant.

Never reverse polarity of battery terminals.
Install only parts specified for a vehicle.
Before replacing the control unit, check the input and output and functions of the component parts.
Do not apply excessive force when disconnecting a connector.
Do not apply excessive shock to the control unit by dropping or hitting it.
Be careful to prevent condensation in the control unit due to rapid temperature changes and do not let water or rain get on it. If water is found in the control unit, dry it fully and then install it in the vehicle.
Be careful not to let oil to get on the control unit connector.
Avoid cleaning the control unit with volatile oil.
Do not disassemble the control unit, and do not remove the upper and lower covers.

Fig 1: Identifying Precaution While Handling Control Unit
Courtesy of NISSAN MOTOR CO., U.S.A.
When using a DMM, be careful not to let test probes get close to each other to prevent the power transistor in the control unit from damaging battery voltage because of short circuiting.
When checking input and output signals of the control unit, use the specified check adapter.

Fig 2: Checking Harness Connector For Solenoid Valve

Courtesy of NISSAN MOTOR CO., U.S.A.