ASCD Brake Switch

WARNING: This page is about a different car, the 2008 Infiniti M35. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch OFF.
Disconnect ASCD brake switch harness connector.

Check harness continuity between ASCD brake switch terminals 1 and 2 under the following conditions.

BRAKE PEDAL CONDITION CHART

Condition	Continuity
Brake pedal: Fully released.	Should exist.
Brake pedal: Slightly depressed.	Should not exist.

If NG, adjust ASCD brake switch installation, refer to "BRAKE PEDAL ", and perform step 3 again.

Fig 1: Checking Harness Continuity Between ASCD Brake Switch Terminals 1 And 2
Courtesy of NISSAN MOTOR CO., U.S.A.