Check Changeover Switch Circuit

CHECK CHANGEOVER SWITCH SIGNAL

With CONSULT-III

Check the operation on (MIR CHNG SW-R" or "MIR CHNG SW-L) in the DATA MONITOR.

DATA MONITOR REFERENCE

Monitor item [OPERATION or UNIT]		Contents
MIR CHNG SW-R	"ON/OFF"	ON/OFF status judged from the changeover switch (switching to RIGHT) signal is displayed.
MIR CHNG SW-L	"ON/OFF"	ON/OFF status judged from the changeover switch (switching to LEFT) signal is displayed.

Without CONSULT-III

Turn ignition switch ON.

Check voltage between automatic drive positioner control unit connector and ground.

VOLTAGE SPECIFICATION

Terminals			Change over switch condition	Voltage (V) (Approx.)
(+)		(-)
Automatic drive positioner control unit connector	Terminal	(-)
M6	2	Ground	RIGHT	0
	2		Other than above	5
	18		LEFT	0
	18		Other than above	5

Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Changeover switch circuit is OK.

NG: GO TO 2.

CHECK HARNESS CONTINUITY

Turn ignition switch OFF.
Disconnect automatic drive positioner control unit and door mirror remote control switch connector.

Check continuity between automatic drive positioner control unit connector and door mirror remote control switch connector.

CONTINUITY SPECIFICATION

A		B		Continuity
Automatic drive positioner control unit connector	Terminal	Door mirror remote control switch connector	Terminal	Continuity
M6	2	M95	3	Yes
M6	18	M95	2	Yes

Check continuity between automatic drive positioner control unit connector and ground.

Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

CONTINUITY SPECIFICATION

A		Ground	Continuity
Automatic drive positioner control unit connector	Terminal		No
M6	2
	18

OK or NG

OK: GO TO 3.

NG: Repair or replace harness.

CHECK CANGEOVER SWITCH

Check door mirror remote control switch.

CONTINUITY SPECIFICATION

Terminal		Change over switch condition	Continuity
Door mirror remote control switch		Change over switch condition	Continuity
2	13	LEFT	Yes
2		Other than above	No
3		RIGHT	Yes
3		Other than above	No

OK or NG

OK: GO TO 4.

Fig 3: Checking Continuity Between Door Mirror Remote Control Switch Connector Terminal

Courtesy of NISSAN MOTOR CO., U.S.A.

NG: Replace door mirror remote control switch.

CHECK DOOR MIRROR REMOTE CONTROL SWITCH GROUND CIRCUIT

Check continuity between door mirror remote control switch connector and ground.

CONTINUITY SPECIFICATION

Door mirror remote control switch connector	Terminal	Ground	Continuity
M95	13	Ground	Yes

OK or NG

OK: GO TO 5.

NG: Repair or replace harness.

Fig 4: Checking Continuity Between Door Mirror Remote Control Switch Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

CHECK AUTOMATIC DRIVE POSITIONER CONTROL UNIT OUTPUT SIGNAL

Connect automatic drive positioner control unit connector.
Turn ignition switch ON.

Check voltage between automatic drive positioner control unit connector and ground.

VOLTAGE SPECIFICATION

Terminals			Voltage (V) (Approx.)
(+)		(-)
Automatic drive positioner control unit connector	Terminal	(-)
M6	2	Ground	5
M6	18	Ground	5

OK or NG

OK: Check the condition of harness and connector.

NG: Replace automatic drive positioner control unit.

Fig 5: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.