Component Function Check

With GST 

1. Start engine and warm it up to normal operating temperature.
2. Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in the suitable gear position.
3. Shift the selector lever position to D, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (31 MPH).
   CAUTION: Always drive vehicle at a safe speed.
   NOTE: Never apply brake when releasing the accelerator pedal.
4. Repeat steps  2 and  3 for 5 times.
5. Stop the vehicle and turn ignition switch OFF.
6. Wait at least 10 seconds and restart engine.
7. Repeat steps  2 and  3 for 5 times.
8. Stop the vehicle and connect GST to the vehicle.
9. Check 1st trip DTC.

   Is 1st trip DTC detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END