Removal and Installation: Installation

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

Note the following, and install in the reverse order of removal.

From below the vehicle, press the grommet (A) into place until the pawls (B) make a click sound.
CAUTION:
- Place the grommet on the floor, then fasten it in place from below the vehicle.
- Check that pulling down on the grommet does not disconnect it.
  
  Fig 1: Identifying Pawls And Grommet
  Courtesy of NISSAN MOTOR CO., U.S.A.
Pay attention to the following when connecting the control cable to the CVT shift selector.

When connecting the control cable (1) to the CVT shift selector assembly (2), face the grooved surface of the rib (A) up and insert the control cable until it stops.

Fig 2: Identifying Control Cable Of CVT Shift Selector Assembly
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the socket (A) onto the CVT shift selector.
CAUTION:
- Place the socket onto the CVT shift lever, then fasten it in place from above.
- Check that the pulling on the socket does not disconnect it.
  
  Fig 3: Identifying Socket Of CVT Shift Selector
  Courtesy of NISSAN MOTOR CO., U.S.A.