LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2010 >> G37 Base, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 232 (Maintenance) >> Periodic Maintenance >> CVT Fluid >> CVT FLUID : Changing

CVT FLUID : Changing

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Replace drain plug gasket with new ones at the final stage of the operation when installing.
  1. Remove drain plug from oil pan.
  2. Remove drain plug gasket from drain plug.
  3. Install drain plug gasket to drain plug.
    CAUTION: Never reuse drain plug gasket.
  4. Install drain plug to oil pan.

    Drain plug - tightening torque : Refer to  "EXPLODED VIEW ".

  5. Fill CVT fluid from CVT fluid charging pipe to the specified level.

    CVT fluid : Refer to  "GENERAL SPECIFICATION ".

    Fluid capacity 

    CAUTION:
    • Use only Genuine NISSAN CVT Fluid NS-2. Never mix with other fluid.
    • Using CVT fluid other than Genuine NISSAN CVT Fluid NS-2 will deteriorate in driveability and CVT durability, and may damage the CVT, which is not covered by the NISSAN new vehicle limited warranty.
    • When filling CVT fluid, take care not to scatter heat generating parts such as exhaust.
    • Sufficiently shake the container of CVT fluid before using.
    • Delete CVT fluid deterioration date with CONSULT-III after changing CVT fluid.
  6. With the engine warmed up, drive the vehicle in an urban area.
    NOTE: When ambient temperature is 20°C (68°F), it takes about 10 minutes for the CVT fluid to warm up to 50 to 80°C (122 to 176°F).
  7. Check CVT fluid level and condition.
  8. Repeat steps  1 to  5 if CVT fluid has been contaminated.
  9. Select "Data Monitor" in "TRANSMISSION" using CONSULT-III.
  10. Select "CONFORM CVTF DETERIORTN".
  11. Select "Erase".
scientia non olet · About LEMON Manuals