Diagnosis Procedure

WARNING: This page is about a different car, the 2011 Nissan Juke. However, it is still accessible from the selected car via links, so may be relevant.

CHECK REAR POWER WINDOW SWITCH INPUT SIGNAL

Turn ignition switch OFF.
Disconnect rear power window switch connector.
Turn ignition switch ON.

Check voltage between rear power window switch harness connector and ground.

VOLTAGE SPECIFICATIONS

(+)			(-)	Condition		Voltage (V)
Rear power window switch
Connector		Terminal
LH	D63	2	Ground	Power window main switch (rear LH side)	NEUTRAL	0 - 1
		2			UP	9 - 16
		3			NEUTRAL	0 - 1
		3			DOWN	9 - 16
RH	D43	2		Power window main switch (rear RH side)	NEUTRAL	0 - 1
		2			UP	9 - 16
		3			NEUTRAL	0 - 1
		3			DOWN	9 - 16

Is the inspection result normal?

YES: GO TO 3.

NO: GO TO 2.

CHECK REAR POWER WINDOW SWITCH CIRCUIT

Turn ignition switch OFF.
Disconnect power window main switch connector.

Check continuity between rear power window switch harness connector and power window main switch harness connector.

CONTINUITY SPECIFICATIONS

Rear power window switch			Power window main switch		Continuity
Connector		Terminal	Connector	Terminal	Continuity
LH	D63	2	D35	9	Existed
LH	D63	3		8
RH	D43	2		7
RH	D43	3		6

Check continuity between rear power window switch harness connector and ground.

CONTINUITY SPECIFICATIONS

Rear power window switch			Ground	Continuity
Connector		Terminal
LH	D63	2		Not existed
		3
RH	D43	2
		3

Is the inspection result normal?

YES: Replace power window main switch. Refer to , "REMOVAL AND INSTALLATION ".

NO: Repair or replace harness.

CHECK REAR POWER WINDOW SWITCH
Check rear power window switch.

Refer to , "COMPONENT INSPECTION ".

Is the inspection result normal?

YES: GO TO 4.

NO: Replace rear power window switch.
CHECK INTERMITTENT INCIDENT
Refer to "INTERMITTENT INCIDENT ".

INSPECTION END