DTC Confirmation Procedure

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1. Turn ignition switch OFF and wait at least 10 seconds.
2. Turn ignition switch ON.
3. Turn ignition switch OFF and wait at least 10 seconds.

   GO TO 2.

With CONSULT-III 

1. Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-III.
2. Start engine and warm it up to normal operating temperature.
3. Drive the vehicle under the following conditions.

   For A/T models

   • Accelerate the vehicle from 0 to 88 km/h (0 to 55 MPH) under the following conditions:
     CAUTION: Always drive at a safe speed.
     NOTE:

     • Accelerate with the accelerator pedal kept constant.
     • The acceleration at engine speed 2, 000 and 3, 000 rpm allows easy diagnoses.
     ENGINE SPEED REFERENCE CHART
     
     

     ACCEL SEN	1 1.4 - 2.0 V
     Selector lever	D position

   For M/T models

   • Accelerate the vehicle from 20 to 88 km/h (13 to 55 MPH) under the following conditions:
     CAUTION: Always drive at a safe speed.
     NOTE:

     • Accelerate with the accelerator pedal kept constant.
     • The acceleration at engine speed 2, 000 and 3, 000 rpm allows easy diagnoses.
     ENGINE SPEED REFERENCE CHART
     
     

     ACCEL SEN 1	1.4 - 2.0 V
     Selector lever	3rd

4. Check 1st trip DTC.

Without CONSULT-III 

1. Start engine and warm it up to normal operating temperature.
2. Drive the vehicle under the following conditions.

   For A/T models

   • With selector lever in D position, accelerate the vehicle from 0 to 88 km/h (0 to 55 MPH) under the following conditions:
     CAUTION: Always drive at a safe speed.
     NOTE:

     • Accelerate with the accelerator pedal kept constant.
     • The acceleration at engine speed 2, 000 and 3, 000 rpm allows easy diagnoses.
     TERMINAL VOLTAGE REFERENCE CHART
     
     

     Accelerator pedal position sensor 1		Ground	Voltage (V)
     Connector	Terminal
     E112	3	Ground	1.4 - 2.0

   For M/T models

   • With selector lever in 3rd position, accelerate the vehicle from 20 to 88 km/h (13 to 55 MPH) under the following conditions:
     CAUTION: Always drive at a safe speed.
     NOTE:

     • Accelerate with the accelerator pedal kept constant.
     • The acceleration at engine speed 2, 000 and 3, 000 rpm allows easy diagnoses.
     TERMINAL VOLTAGE REFERENCE CHART
     
     

     Accelerator pedal position sensor 1		Ground	Voltage (V)
     Connector	Terminal
     E112	3	Ground	1.4 - 2.0

3. Check 1st trip DTC.

   Is 1st trip DTC detected? 

   YES: Go to "DIAGNOSIS PROCEDURE ".

   NO: INSPECTION END