LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2010 >> FX50 >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Engine Control System (VQ35HR) - Introduction, DTC Index, Function & Component Diagnosis) >> Function Diagnosis >> On Board Diagnostic (OBD) System >> Diagnosis Description >> Malfunction Indicator Lamp (Mil) >> How To Set Diagnostic Test Mode II (Self-Diagnostic Results)

How To Set Diagnostic Test Mode II (Self-Diagnostic Results)

WARNING: This page is about a different car, the 2010 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Confirm that accelerator pedal is fully released, turn ignition switch ON and wait 3 seconds.
  2. Repeat the following procedure quickly 5 times within 5 seconds.
    • Fully depress the accelerator pedal.
    • Fully release the accelerator pedal.
  3. Wait 7 seconds, fully depress the accelerator pedal and keep it depressed for approx. 10 seconds until the MIL starts blinking.
    NOTE: Do not release the accelerator pedal for 10 seconds if MIL starts blinking during this period. This blinking is displaying SRT status and is continued for another 10 seconds.
  4. Fully release the accelerator pedal.

    ECM has entered to Diagnostic Test Mode II (Self-diagnostic results).

    NOTE: Wait until the same DTC (or 1st trip DTC) appears to completely confirm all DTCs.
    Fig 1: Identifying Diagnostic Test Mode
    G04874812Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals