LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2010 >> FX35 RWD >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System (VQ35HR) - Introduction, DTC Index, Function & Component Diagnosis >> Function Diagnosis >> On Board Diagnostic (OBD) System >> Diagnosis Tool Function >> Inspection Procedure

Inspection Procedure

  1. Turn ignition switch OFF.
  2. Connect "GST" to data link connector (1), which is located under LH dash panel near the hood opener handle.
    Fig 1: Identifying Data Link Connector
    G05978412Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Enter the program according to instruction on the screen or in the operation instructions.

    *: Regarding GST screens in this information sample screens are shown.

    Fig 2: Display - GST Sample Screen
    G04874897Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Perform each diagnostic mode according to each service procedure.

    For further information, see the GST Operation instructions of the tool maker. 

    Fig 3: Generic Scan Tool Screen Display - READINESS TESTS
    G04874898Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About LEMON Manuals