Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

• When installing the transfer to the transmission, install the mounting bolts following the standard below, tighten bolts to the specified torque.
  BOLTS REFERENCE CHART
  
  

  Bolt No.	1	2	3	4
  Quantity	4	3	2	1
  Bolt length "l  " mm (in)	75 (2.95)	45 (1.77)	40 (1.57)	30 (1.18)

  • : Transfer to transmission.

  ◦ : Transmission to transfer.

  Fig 1: Identifying Mounting Bolts

  Courtesy of NISSAN MOTOR CO., U.S.A.
• When installing transfer air breather hose, make sure there are no pinched or restricted areas on the transfer air breather hose caused by bending or winding.
  • Set transfer air breather hose with paint mark facing upward.
  • Be sure to insert transfer air breather hose (1) into breather tube (2) until hose end reaches the tube's base.
    Fig 2: Identifying Air Breather Hose And Breather Tube

    Courtesy of NISSAN MOTOR CO., U.S.A.
  • Do not deviate from the range (L) of the transfer air breather when installing the transfer air breather hose (1) to the harness bracket (2) of the transfer.
    Fig 3: Identifying Transfer Air Breather Hose Distance

    Courtesy of NISSAN MOTOR CO., U.S.A.
  • Install transfer air breather hose (1) with bracket between the adapter case (2) and the transmission case (3) as shown in the figure.
    Fig 4: Identifying Transfer Air Breather Hose With Bracket Between Adapter Case And Transmission Case

    Courtesy of NISSAN MOTOR CO., U.S.A.
  • Be sure to insert air breather hose (1) to transfer tube until hose end reaches the tube bend R portion.
• After the installation, check the fluid level, fluid leakage and the A/T positions. Refer to "INSPECTION ".
  Fig 5: Inserting Air Breather Hose To Transfer Tube Until Hose End Reaches Tube Bend R Portion

  Courtesy of NISSAN MOTOR CO., U.S.A.