Removal and Installation: Removal

WARNING: This page is about a different car, the 2008 Infiniti FX45 and 2008 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Remove low-pressure pipe 2 and high-pressure pipe 3. Refer to "REMOVAL AND INSTALLATION OF LOW-PRESSURE PIPE 2 AND HIGH-PRESSURE PIPE 3 ".
CAUTION: Cap or wrap the joint of evaporator, low-pressure pipe 1 and high-pressure pipe 2 with suitable material such as vinyl tape to avoid the entry of air.
Slide evaporator to passenger side, and then remove intake sensor.

Fig 1: Identifying Intake Sensor

Courtesy of NISSAN MOTOR CO., U.S.A.