Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Infiniti FX45 and 2008 Infiniti FX35. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

CAUTION:

Fix the air bag module harness (shown as A in Fig 1) to the harness fixing hook (shown as B in Fig 1.

Fig 1: Identifying Air Bag Module Harness
Courtesy of NISSAN MOTOR CO., U.S.A.
Be careful not to damage the harness while installing.
Tighten the special bolts after exactly adjusting the centers of fixing holes on the air bag module side and the steering wheel side. If the holes are misaligned, the bolt threads are damaged and the module is not installed securely.
After the work is completed, make sure no system malfunction is detected by air bag warning lamp.
In case that malfunction is detected by the air bag warning lamp, reset by the self-diagnosis function and delete the memory by CONSULT-III.
In case that malfunction is still detected after the above operation, perform self-diagnosis to repair malfunctions. Refer to "SRS OPERATION CHECK ".