Rear Power Window Switch: Removal

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.

REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH
1. Using a screwdriver, detach the 2 clips and 5 claws, and remove the rear upper door armrest base panel.
  
  Fig 1: Identifying Rear Upper Door Armrest Base Panel LH
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  
  Tape the screwdriver tip before use.
2. Disconnect the connector.
  
  Fig 2: Identifying Rear Upper Door Armrest Base Panel LH Connectors
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
1. Detach the 2 claws and remove the regulator switch.
  
  Fig 3: Identifying Rear Power Window Regulator Switch Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002