Combination Meter: Removal

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
NOTE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY
1. Detach the 4 claws.
  
  Fig 1: Identifying Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. for Column Shift Type:
  Move the shift lever to the S position.
3. Detach the 12 clips.
4. Disconnect the connectors and clamps.
  
  Fig 2: Identifying Connectors And Clamps
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Remove the wire harness from the slots, and then remove the finish panel.
  
  Fig 3: Identifying Wire Harness Slots
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COMBINATION METER ASSEMBLY
1. Remove the 4 screws.
  
  Fig 4: Identifying Combination Meter Assembly Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Disconnect the connector and clamp, and remove the combination meter.
  
  Fig 5: Identifying Combination Meter Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002