Fog Light Assembly: Removal

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

Use the same procedures for the RH and LH side.
The procedures listed below are for the LH side.

REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
REMOVE FOG LIGHT ASSEMBLY LH
1. for Steel Type Bumper:
  
  Fig 1: Identifying LH Fog Light Assembly Claws (Steel Type Bumper)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Disconnect the connector.
  2. Push the tabs on the grommet.
  3. Detach the 2 claws and remove the fog light.
2. for Resin Type Bumper:
  
  Fig 2: Identifying LH Fog Light Assembly Claws (Resin Type Bumper)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Disconnect the connector.
  2. Push the tabs on the aiming screw.
  3. Detach the 2 claws and remove the fog light.