Cargo Light Switch: Inspection

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

INSPECT CARGO LIGHT SWITCH

Measure the resistance according to the value(s) in the table below.

Fig 1: Identifying Cargo Light Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Standard resistance

CARGO LIGHT SWITCH

Tester Connection	Switch Condition	Specified Condition
5 (FCTY) - 9 (FLON)	Cargo light switch ON	Below 1 Ω
	Cargo light switch DOOR	Below 1 Ω
	Cargo light switch OFF	10 kΩ or higher
10 (FLMP) - 7 (E)	Cargo light switch ON	Below 1 Ω
	Cargo light switch DOOR	10 kΩ or higher
	Cargo light switch OFF	10 kΩ or higher

If the result is not as specified, replace the switch.

Inspect the switch illumination.
1. Connect the battery's positive (+) lead to terminal 1 (ILL+) and the negative (-) lead to terminal 4 (ILL-).
2. Check that the door courtesy light comes on.
  OK: Light comes on.
  
  If the result is not as specified, replace the light switch.