Yaw Rate And Deceleration Sensor: Removal
WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- REMOVE CENTER FRONT SEAT ASSEMBLY (for Center Seat) (See REMOVAL )
- REMOVE CONSOLE BOX ASSEMBLY (for Separate Seat Type)
- Remove the console box (see REMOVAL ).
- REMOVE YAW RATE SENSOR
- Remove the 2 nuts (labeled A) and sensor.
- Disconnect the sensor connector (labeled B), and then detach the clamp (labeled C) from the sensor bracket.