Skid Control Buzzer: Removal
WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
- DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL NOTE:
- After the ignition switch is turned OFF, the navigation system requires approximately 90 seconds to record various types of memory and settings. As a result, after turning the ignition switch OFF, wait 90 seconds or more before disconnecting the cable from the negative (-) battery terminal.
- Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
- REMOVE FRONT DOOR SCUFF PLATE LH (for Regular Cab) (See REMOVAL )
- REMOVE FRONT DOOR SCUFF PLATE LH (for Double Cab, CrewMax) (See )
- REMOVE COWL SIDE TRIM BOARD LH (See REMOVAL )
- REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY LH (See REMOVAL )
- REMOVE SKID CONTROL BUZZER ASSEMBLY
- Detach the clamp and remove the buzzer.
- Disconnect the buzzer connector.