LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M45 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Supplemental Restraint System) >> Front Airbag Sensor >> Installation

Front Airbag Sensor: Installation

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL FRONT AIRBAG SENSOR 
    1. Check that the ignition switch is OFF.
    2. Check that the cable is disconnected from the battery negative (-) terminal.
      CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
    3. Connect the connector.
    4. Install the front airbag sensor with the nut.

      Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf) 

      Fig 1: Locating Nut & Front Airbag Sensor
      G05156047Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      NOTE:
      • If the front airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
      • When installing the front airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
    5. Check that there is no looseness in the installation parts of the front airbag sensor.
  2. INSTALL BATTERY 
    1. Set the battery in the vehicle. Then move the stay onto the battery and tighten the nut to fix the battery in place.
    2. Connect the cable to the positive (+) battery terminal.
      3. Fig 2: Locating Nuts
      G05156046Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
    NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).
  4. CHECK SRS WARNING LIGHT 
    1. Check the SRS warning light (see DIAGNOSIS SYSTEM  ).
scientia non olet · About LEMON Manuals