Exiting Operation

When exiting, when the condition is satisfied, the seat is moved backward 40 mm (1.57 in) from normal sitting position and the steering is moved to the most upper position and front position.

The seat slide amount and the steering operation at entry/exit operation can be changed by set switch, CONSULT-III and display (located in the instrument panel). Refer to "SETTING CHANGE FUNCTION ".

Operation Condition

• Ignition switch: OFF/Driver side door switch: ON (OPEN)

If the following conditions are not satisfied, exiting operation is not performed.

• Ignition switch is in OFF position.
• Selector lever position is in P position.
• Vehicle speed is less than 7 km/h. (4 MPH).
• Driver side power seat switch and ADP steering switch are not operated.
• Seat memory switch and set switch is not operated.
• Door mirror control switch is not operated at change over switch is in LH or RH position.
• Output malfunction is not detected.
• Detention switch malfunction is not detected.

  [Detention switch malfunction is sensed when detention switch remains OFF and vehicle speed is higher than 7 km/h. (4 MPH).]

• CAN communications are normal.
• Initialization has been done. Refer to "INITIALIZATION PROCEDURE ".