Check Tilt Switch Circuit

CHECK FUNCTION

With CONSULT-III

With "TILT SW-UP, TILT SW-DOWN" on the DATA MONITOR, operate the ADP steering switch to check ON/OFF operation.

MONITOR ITEM CHART

Monitor item [OPERATION or UNIT]		Contents
TILT SW-UP	"ON/OFF"	(ON/OFF) status judged from the tilt switch (UP) signal is displayed.
TILT SW-DOWN	"ON/OFF"	(ON/OFF) status judged from the tilt switch (DOWN) signal is displayed.

Without CONSULT-III

Check voltage between automatic drive positioner control unit connector and ground.

VOLTAGE SPECIFICATION

Automatic drive positioner control unit connector	Terminals		Tilt switch condition	Voltage (V) (Approx.)
Automatic drive positioner control unit connector	(+)	(-)	Tilt switch condition	Voltage (V) (Approx.)
M6	1	Ground	UP	0
	1		Other than above	5
	17		DOWN	0
	17		Other than above	5

Fig 1: Checking Voltage Between Automatic Drive Positioner Control Unit Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Tilt switch circuit is OK.

NG: GO TO 2.

CHECK TILT SWITCH CIRCUIT HARNESS CONTINUITY

Disconnect automatic drive positioner control unit connector and ADP steering switch connector.

Check continuity between automatic drive positioner control unit connector and ADP steering switch connector.

CONTINUITY CHART

A		B		Continuity
Automatic drive positioner control unit connector	Terminal	ADP steering switch connector	Terminal	Continuity
M6	1	M46	2	Yes
M6	17	M46	3	Yes

Check continuity between automatic drive positioner control unit connector and ground.

CONTINUITY CHART

A		Ground	Continuity
Automatic drive positioner control unit connector	Terminal
M6	1		No
	17

Fig 2: Checking Continuity Between Automatic Drive Positioner Control Unit And ADP Steering Switch Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 3.

NG: Repair or replace harness.

CHECK ADP TILT STEERING SWITCH

ADP steering switch operate, check continuity ADP steering switch.

TERMINAL REFERENCE

ADP steering switch	Terminal		ADP steering switch condition	Continuity
M46	2	1	UP	Yes
	2		Other than above	No
	3		DOWN	Yes
	3		Other than above	No

Fig 3: Checking Continuity ADP Steering Switch

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: GO TO 4.

NG: Replace ADP steering switch.

CHECK ADP STEERING SWITCH GROUND CIRCUIT

Check continuity between ADP steering switch connector and ground.

CONTINUITY CHART

ADP steering switch connector	Terminal	Ground	Continuity
M46	1	Ground	Yes

Fig 4: Checking Continuity Between ADP Steering Switch Connector And Ground

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG

OK: Replace automatic drive positioner control unit.

NG: Repair or replace harness.