Conventional (Fixed Speed) Cruise Control Mode

Set Checking

Press the MAIN switch for more than 1.5 seconds.
Drive the vehicle at 40 km/h (25 MPH) or more.
Push down the SET/COAST switch.
Confirm that the desired speed is set as hand is released from the SET/COAST switch.
NOTE: The set vehicle speed is not displayed on the dot matrix LCD in the combination meter.

Check For Increase Of Cruising Speed

Set the conventional (fixed speed) cruise control mode at desired speed.
Check if the set speed increases by 1.6 km/h (1 MPH) as RESUME/ACCELERATE switch is pushed up.
NOTE:
- If the RESUME/ACCELERATE switch is kept pushing up during cruise control driving, the vehicle speed increases until the switch is released.
- The maximum set speed is 144 km/h (90 MPH).
CAUTION: Never set the cruise speed exceeding the posted speed limit.

Check For Decrease Of Cruising Speed

Set the conventional (fixed speed) cruise control mode at desired speed.
Check if the set speed decreases by 1.6 km/h (1 MPH) as SET/COAST switch is pushed down.
NOTE:
- Conventional (fixed speed) cruise control mode is automatically cancelled when the driving speed lowers to 32 km/h (20 MPH).
- The lowest set speed is 40 km/h (25 MPH).

Check For Cancellation Of Conventional (Fixed Speed) Cruise Control Mode (Normal Driving Condition) In The Following Cases:

Refer to .

Check For Restoring Speed That Is Set By Conventional (Fixed Speed) Cruise Control Mode Before ICC Cancellation

Refer to .

Check For MAIN Switch

Start engine. Then, check if the following operations are performed correctly.
"CRUISE" lamp illuminates and dot matrix LCD goes off when MAIN switch is pressed "ON" for more than 1.5 seconds, and then ready for operation. The illumination goes off when MAIN switch is turned to OFF.
"CRUISE" illumination go off when the ignition switch is turned to OFF while MAIN switch is ON.

Fig 1: Locating MAIN Switch
Courtesy of NISSAN MOTOR CO., U.S.A.

Check For RESUME/ACCELERATE, SET/COAST, CANCEL Switches