Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

CHECK PANEL SWITCH
1. Check for foreign matter around the switch that might prevent operation.
  OK: No foreign matter is found.
NG: REMOVE ANY FOREIGN MATTER

OK: Go to Next Step

CHECK PANEL SWITCH (DISPLAY CHECK MODE)

Enter the "Display Check" mode (Panel Switch Check Mode) (see DISPLAY CHECK MODE ).

Operate the abnormal switch and check if the switch name and status are correctly displayed.

OK: The switch name and status are correctly displayed as operated.

Result

PANEL SWITCH (DISPLAY CHECK MODE) RESULT CHART

Result	Proceed to
OK (for Column Shift Type)	A
OK (for Floor Shift Type)	B
NG	C

Fig 1: Diagnostic Menu Screen Display - Panel Switch Check Mode

B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )

C: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

A: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )