Inspection Procedure

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

After the inspection is completed, clear the DTCs (see DTC CHECK/CLEAR ).

CHECK NAVIGATION RECEIVER

Check if a disc can be inserted or ejected normally.

OK: A disc can be inserted or ejected normally.

Result

NAVIGATION RECEIVER RESULT CHART

Result	Proceed to
OK	A
NG (for Column Shift Type)	B
NG (for Floor Shift Type)	C

B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )

C: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )

A: Go to Next Step

DTC CLEAR AND RECHECK

Clear the DTCs (see DTC CHECK/CLEAR ).

Recheck for DTCs and check if the same trouble occurs again.

OK: Same problem does not occur.

Result

DTC RESULT CHART

Result	Proceed to
OK	A
NG (for Column Shift Type)	B
NG (for Floor Shift Type)	C

B: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Column Shift Type) )

C: REPLACE NAVIGATION RECEIVER (see REMOVAL (For Floor Shift Type) )

A: USE SIMULATION METHOD TO CHECK (See ELECTRONIC CIRCUIT INSPECTION PROCEDURE )