DTC 01-DC Transmission Error: Description
WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
DTC TROUBLE DETECTION CONDITION
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-DC* | Transmission to component shown by subcode failed (Detecting this DTC does not always mean actual failure) | If the same sub-code is recorded in other components, check harness for power supply and communication system of all components shown by code |
| HINT: *: This code may be stored if the engine is started, idled for 60 seconds and then the ignition switch is turned to the START position again. |
||
NOTE:
- Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The radio receiver is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.