Oil Pressure Switch: Installation

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL OIL PRESSURE SWITCH
1. Apply adhesive to 2 or 3 threads of the oil pressure switch.
  Adhesive:
  
  Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent
  
  Fig 1: Applying Adhesive To Oil Pressure Switch
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using a 24 mm deep socket wrench, install the oil pressure switch.
  Torque: 15 N*m (150 kgf*cm, 11 ft.*lbf)
  
  NOTE: Do not start the engine within 1 hour of installation.
  
  Fig 2: Installing Oil Pressure Switch Using Socket Wrench
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the oil pressure switch connector.
INSTALL V-BANK COVER (See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
NOTE: Some systems need to be initialized after the cable is reconnected (see INITIALIZATION ).