LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 22 (Wiper System & Washer System) >> Wiper And Washer System >> Data List / Active Test

Data List / Active Test

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. DATA LIST 

    HINT:

    Using the Techstream to read the DATA LIST allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the DATA LIST information early in troubleshooting is one way to save diagnostic time.

    NOTE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
    1. Warm up the engine.
    2. Turn the ignition switch OFF.
    3. Connect the Techstream to the DLC3.
    4. Turn the ignition switch ON.
    5. Turn the tester on.
    6. Enter the following menus:

      Techstream - Select: Body / Combination Meter / Data List.

    7. According to the display on tester, read the "Data List".

      Techstream 

      COMBINATION METER

      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Washer Switch Washer fluid level warning switch / ON or OFF ON: Washer jar is empty
      OFF: Washer jar is full      		 -
scientia non olet · About LEMON Manuals