LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2009 >> M35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 154 (Supplemental Restraint System) >> Front Airbag Sensor >> On-Vehicle Inspection

On-Vehicle Inspection

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK FRONT AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION) 
    1. Perform a diagnostic system check (see DIAGNOSIS SYSTEM  ).
  2. CHECK FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED) 
    1. Perform a diagnostic system check (see DIAGNOSIS SYSTEM  ).
    2. When the front bumper of the vehicle or its area is damaged, check if there is any damage to the front airbag sensor, if the front airbag sensor has defects as mentioned below, replace it with a new one:
      • Cracks, dents or chips on the sensor housing.
      • Cracks or other damage to the connector.
      • Peeling off of the label or damage to the serial number.
      CAUTION: For removal and installation procedures of the front airbag sensor, be sure to follow the correct procedure.
  3. CHECK FRONT AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED) 
    1. Replace the front airbag sensor.
      CAUTION:
      • For removal and installation procedures of the front airbag sensor, be sure to follow the correct procedure.
      • If the airbags have deployed, replace the front airbag sensor on the side in which the collision occurred. Replace both if necessary.
scientia non olet · About LEMON Manuals