Rear Engine Mounting: Installation

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.

SUPPORT AUTOMATIC TRANSMISSION ASSEMBLY
1. Support the transmission with a transmission jack. Lift the transmission slightly off of the crossmember.
  
  Fig 1: Supporting Transmission With Transmission Jack
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL REAR NO. 1 ENGINE MOUNTING INSULATOR
1. Install the engine mounting insulator to the transmission with the 4 bolts.
  Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
  
  Fig 2: Locating Rear No. 1 Engine Mounting Insulator Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSTALL NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY
1. Install the frame crossmember to the engine rear mounting insulator with the 4 bolts.
  Torque: 16 N*m (63 kgf*cm, 12 ft.*lbf)
  
  Fig 3: Identifying Frame Crossmember To Rear Engine Mounting Insulator With Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the frame crossmember with the 4 bolts, 4 plate washers and 4 nuts.
  Torque: 110 N*m (1122 kgf*cm, 81 ft.*lbf)
  
  Fig 4: Identifying Frame Crossmember With Bolts, Washers And Nuts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002