Setting Procedure

STEP-1
Set the vehicle to the following condition.
- Ignition position: ACC
- A/T selector lever: P position (A/T models)
- Parking brake: Applied only (M/T models)
  GO TO 2.
STEP-2
Press set switch and hold for more than 10 seconds, then confirm blinking of the memory switch indicator.
- Seat synchronization are ON : Memory switch indicator blink two times.
- Seat synchronization are OFF : Memory switch indicator blink once.
  NOTE:
  - After memory setting registration, by pushing set switch for approximately 10 seconds, memory switch indicator lamp turns 4 seconds. turns OFF, blinks 1 or 2 times, and then the switching operation is complete. Push and hold set switch during the switching operation.
  END.