Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

CAUTION:

Be careful not to damage connector when installing any connector.
Never reuse drain plug and drain plug gasket.
Never reuse O-ring.
Apply ATF to O-ring.
Adjust bolt hole of bracket to bolt hole of control valve with TCM when installing A/T fluid temperature sensor 2 (with bracket).

Refer to the following when installing control valve with TCM to transmission case.

CAUTION:

Make sure that turbine revolution sensor securely installs turbine revolution sensor holes (B).
A : Brake band

Fig 1: Identifying Turbine Revolution Sensor Holes
Courtesy of NISSAN MOTOR CO., U.S.A.
Hang down revolution sensor harness toward outside so as not to disturb installation of control valve with TCM.
Adjust A/T assembly harness connector of control valve with TCM to terminal hole of transmission case.
Assemble it so that manual valve (1) cutout is engaged with manual plate (2) projection.

Fig 2: Identifying Manual Valve And Manual Plate
Courtesy of NISSAN MOTOR CO., U.S.A.

Install bolts (A), (B) and (C) to control valve with TCM. Tighten bolt 1, 2 and 3 temporarily to prevent dislocation. After that tighten them in order (1 → 2 → 3), and then tighten other bolts. Tighten control valve with TCM bolts to the specified torque.

<=: Vehicle front

Fig 3: Identifying Bolts

Courtesy of NISSAN MOTOR CO., U.S.A.

BOLT SYMBOL SPECIFICATION

Bolt symbol	A	B	C
Number of bolts	5	6	1
Length mm (in)	42 (1.65)	55 (2.17)	40 (1.57)
Tightening torque N.m (kg-m, in-lb)	7.9 (0.81, 70)		With ATF applied
Tightening torque N.m (kg-m, in-lb)	7.9 (0.81, 70)		7.9 (0.81, 70)

Refer to the following when installing oil pan (2) (with oil pan gasket) and clips (1) to transmission case.

Fig 4: Locating Oil Pan Bolts
Courtesy of NISSAN MOTOR CO., U.S.A.
CAUTION:
- Never reuse oil pan gasket and oil pan mounting bolts.
- Install oil pan gasket in the direction to align hole position.
- Install it so that drain plug comes to the position as shown in the figure.
- Be careful not to pinch harnesses.
- Completely remove all moisture, oil and old gasket, etc. from oil pan mounting surface.
- Tighten oil pan mounting bolts to the specified torque in numerical order shown in the figure after temporarily tightening them. Tighten oil pan mounting bolts to the specified torque.
  
  Fig 5: Identifying Oil Pan Bolts Tightening Sequence
  Courtesy of NISSAN MOTOR CO., U.S.A.