Component Inspection

CHECK SELECTOR LEVER POSITION INDICATOR

Check that selector lever position indicator lamps turn on.

CAUTION: Connect the fuse between the terminals when applying the voltage.

SELECTOR LEVER POSITION

Selector lever position indicator connector			Condition	Status
Connector	Terminal
Connector	+ (fuse)	-
M223	3	8	Apply 12 V direct current between terminals 3 and 8.	"N" position indicator lamp turns on.
	4		Apply 12 V direct current between terminals 4 and 8.	"D" position indicator lamp turns on.
	5		Apply 12 V direct current between terminals 5 and 8.	"R" position indicator lamp turns on.
	7		Apply 12 V direct current between terminals 7 and 8.	"P" position indicator lamp turns on.
	6	2	Apply 12 V direct current between terminals 6 and 2.	"M" mode indicator lamp turns on.
	1	9	Apply 12 V direct current between terminals 1 and 9.	Illumination lamp turns on.

Is the inspection result normal?

YES: INSPECTION END

NO: Replace the selector lever position indicator. Refer to "2WD : EXPLODED VIEW " (2WD), "AWD : EXPLODED VIEW " (AWD).