Preliminary Check

INSPECTION START
Turn ignition switch "OFF" and pull out Intelligent Key from key slot.

NOTE: Before starting operation check, open front windows.

>> GO TO 2.
CHECK SECURITY INDICATOR LAMP
1. Lock doors using Intelligent Key or mechanical key.
2. Make sure security indicator lamp illuminate for 30 seconds.
Security indicator lamp should illuminate.

OK: GO TO 3.

NG: Perform diagnosis and repair. Refer to "DIAGNOSTIC PROCEDURE 1 ".
CHECK ALARM FUNCTION
1. After 30 seconds, security indicator lamp will start blink.
2. Open any door or hood before unlocking with Intelligent Key or mechanical key, or open trunk lid without Intelligent Key or mechanical key.
Do alarm function properly.

OK: GO TO 4.

NG: Check the following.
- The vehicle security system does not phase in alarm mode. Refer to "DIAGNOSTIC PROCEDURE 2 ".
- Alarm (horn, headlamp and hazard lamp) do not operate. Refer to "DIAGNOSTIC PROCEDURE 3 ".
CHECK ALARM CANCEL OPERATION
Unlock any door or open trunk lid using Intelligent Key or mechanical key.

Alarm (horn, headlamp and hazard lamp) should stop.

OK: INSPECTION END.

NG: Perform diagnosis and repair. Refer to "DIAGNOSTIC PROCEDURE 4 ".