Torque Specifications
WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Part Tightened | N*m | kgf*cm | ft.*lbf | |
|---|---|---|---|---|
| No. 2 timing belt idler pulley x Cylinder block | 35 | 357 | 26 | |
| No. 1 timing belt idler pulley x Cylinder block | 35 | 357 | 26 | |
| Timing belt tensioner x Oil pump | 26 | 265 | 19 | |
| No. 1 timing belt cover x oil pump | 7.5 | 76 | 66 in.*lbf | |
| Pulley set bolt x Crankshaft | 245 | 2498 | 181 | |
| Fan bracket x Cylinder block | for nut A, bolt B | 16 | 163 | 12 |
| for nut C, bolt D | 32 | 326 | 24 | |
| V-ribbed belt tensioner x Cylinder block | 16 | 163 | 12 | |
| No. 2 timing belt cover x Cylinder block | 16 | 163 | 12 | |
| No. 3 timing belt cover LH x Cylinder head | 7.5 | 76 | 66 in.*lbf | |
| No. 3 timing belt cover RH x Cylinder head | 7.5 | 76 | 66 in.*lbf | |
| No. 2 idle pulley x Fan bracket | 39 | 398 | 29 | |
| oil cooler pipe x Fan bracket, No. 3 timing belt cover LH | 7.5 | 76 | 66 in.*lbf | |
| Cooler compressor x Cylinder block | 47 | 479 | 35 | |
| Cooler compressor x Oil filter bracket | 25 | 255 | 18 | |
| Vane pump x Cylinder block | 28 | 286 | 21 | |
| fan shroud x Radiator | 6.5 | 66 | 58 in.*lbf | |
| Fluid coupling x Fan bracket | 29 | 296 | 21 | |
| Cylinder head x Cylinder block | 1st | 32 | 326 | 24 |
| 2nd | Turn 90° | Turn 90° | Turn 90° | |
| 3rd | Turn 90° | Turn 90° | Turn 90° | |
| Camshaft bearing cap x Cylinder head | for bolt 21 and 22 | 7.5 | 76 | 66 in.*lbf |
| for other bolt | 16 | 163 | 12 | |
| Rear No. 1 timing belt plate x Cylinder head | 7.5 | 76 | 66 | |
| Camshaft timing pulley x Camshaft timing tube | 8.1 | 83 | 72 | |
| Cylinder head cover x Cylinder head | 10 | 102 | 7 | |
| Rear water by-pass joint x Cylinder head | 18 | 184 | 13 | |
| Water by-pass pipe x Rear water by-pass joint | 18 | 184 | 13 | |
| front water by-pass joint x Cylinder head | 18 | 184 | 13 | |
| Stud bolt x Cylinder head | 9.0 | 92 | 80 in.*lbf | |
| Connecting rod cap x Connecting rod | 1st | 25 | 255 | 18 |
| 2nd | Turn 90° | Turn 90° | Turn 90° | |
| Crankshaft bearing cap x Cylinder block | 1st | 27 | 275 | 20 |
| 2nd | Turn 90° | Turn 90° | Turn 90° | |
| Stud bolt x Cylinder block | for stud bolt A, B, F | 8.0 | 82 | 71 in.*lbf |
| for stud bolt C | 20 | 204 | 15 | |
| for stud bolt D | 12 | 122 | 9 | |
| for stud bolt E | 14 | 143 | 10 | |
| No. 1 oil nozzle x Cylinder block | 9.0 | 92 | 80 in.*lbf | |
| Engine mounting insulator x Body | 79 | 806 | 58 | |
| Drive gear and ring gear x Crankshaft | 1st | 30 | 306 | 22 |
| 2nd | Turn 90° | Turn 90° | Turn 90° | |
| Engine wire x Engine room junction block | 10 | 102 | 7 | |
| Ground wire x Air injection control driver bracket | 8.0 | 82 | 71 in.*lbf | |
| Engine wire x Positive battery terminal | 13 | 133 | 10 | |
| Ground wire x Cylinder head cover RH | 8.0 | 82 | 71 in.*lbf | |
| Air pump connector bracket x Cylinder head cover RH | 4.0 | 41 | 35 in.*lbf | |
| Hood x Hood hinge | 13 | 133 | 10 | |
| Oil seal retainer x Cylinder block | 8.0 | 82 | 71 in.*lbf | |
| Water drain cock x Cylinder block | 49 | 500 | 36 | |
| Drive gear x Camshaft timing tube | 7.5 | 76 | 66 in.*lbf | |
| Camshaft timing tube x Camshaft | 78 | 795 | 58 | |
| Screw plug x Camshaft timing tube | 15 | 153 | 11 | |
| Oil filer cap housing x Cylinder head cover LH | 10 | 102 | 7 | |
| Front No. 1 engine mounting bracket x Cylinder block | 36 | 367 | 27 | |
| Front engine mounting insulator x Front No. 1 engine mounting bracket | 72 | 734 | 53 | |
| No. 2 wiring harness heat insulator x Cylinder block | 17 | 173 | 13 | |
| Air tube x Rear water bypass joint | for bolt A | 10 | 102 | 7 |
| Air tube x Cylinder head LH | for bolt B | 16 | 163 | 12 |
| Rear No. 1 engine mounting insulator x Automatic transmission for 2WD | 40 | 408 | 30 | |
| Rear No. 1 engine mounting insulator x Automatic transmission for 4WD | 59 | 602 | 44 | |
| Mounting heat insulator x Rear No. 1 engine mounting insulator | 12 | 122 | 9 | |
| No. 3 frame crossmember x Body | 110 | 1122 | 81 | |
| Rear No. 1 engine mounting insulator x No. 3 frame crossmember | 16 | 163 | 12 | |
| Air cleaner case x Body | 5.0 | 51 | 44 in.*lbf | |
| Air cleaner hose x Hose clamp | 4.0 | 41 | 35 in.*lbf | |