Outer Rear View Mirror: Installation

HINT:

• Use the same procedures for the LH side and RH side.
• The procedures listed below are for the LH side.

1. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY 
   Fig 1: Identifying Outer Rear View Mirror Nuts

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
   1. Temporarily install the mirror by inserting the claw on the mirror into the holes on the vehicle.
   2. Tighten the 3 nuts in the sequence shown in the illustration and install the mirror.

      Torque: 7.8 N*m (80 kgf*cm, 69 in.*lbf) 

   3. w/ Power mirror control system:

      Connect the connector labeled A.

2. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY  (See REASSEMBLY )
3. INSTALL COURTESY LIGHT ASSEMBLY (w/ Power Window)  (See REASSEMBLY )
4. INSTALL FRONT LOWER DOOR FRAME BRACKET GARNISH  (See REASSEMBLY )
5. INSTALL FRONT DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)  (See REASSEMBLY )
6. INSTALL FRONT UPPER ARMREST BASE PANEL (w/ Power Window)  (See REASSEMBLY )
7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG  (See REASSEMBLY )