Removal and Installation: Installation
- Installation is the reverse order of removal. For tightening torque. Refer to
"COMPONENTS ".CAUTION: Do not reuse non-reusable parts.
- Assemble disc rotor and wheel hub and bearing assembly by aligning each matching mark (A) as shown in the figure when installing disc rotor.
- Perform final tightening of rear suspension member and axle installation position (rubber bushing) under unladen condition with tires on level ground. Check wheel alignment. Refer to "WHEEL ALIGNMENT INSPECTION ".
- Adjust neutral position of steering angle sensor after checking the wheel alignment. Refer to "ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION ".