LEMON Manuals: Even more car manuals for everyone
Home >> Infiniti >> 2008 >> M35 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Transfer Case -JF1A) >> Transfer Oil >> Replacement

Transfer Oil: Replacement

WARNING: This page is about a different car, the 2008 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. DRAIN TRANSFER OIL 
    1. Remove the 4 bolts and lower transfer case protector.
      2. Fig 1: Identifying Lower Transfer Case Protector Bolts
      G05158937Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the filler plug and gasket.
    3. Remove the drain plug and gasket, and drain the transfer oil.
  2. ADD TRANSFER OIL 
    1. Install a new gasket and the drain plug.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    2. Pour oil so that the oil level is between 0 to 5.0 mm (0 to 0.197 in.) from the bottom lip of the filler plug hole.
      NOTE:
      • Pour oil slowly.
      • Pour oil a little at a time, waiting several minutes between each addition of oil.
    3. Wait approximately 5 minutes and check that the oil level has not changed.
    4. Install a new gasket and the filler plug.

      Torque: 37 N*m (377 kgf*cm, 27 ft.*lbf) 

    5. Install the lower transfer case protector with the 4 bolts.

      Torque: 18 N*m (184 kgf*cm, 13 ft.*lbf) 

      Fig 2: Identifying Lower Transfer Case Protector Bolts
      G05158937Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals