Line Pressure Test Procedure
- Inspect the amount of engine oil and replenish if necessary.
- Drive the car for about 10 minutes to warm it up so that the ATF reaches in range of 50 to 80°C (122 to 176°F). Then inspect the amount of ATF and replenish if necessary.NOTE: The A/T fluid temperature rises in range of 50 to 80°C (122 to 176°F) during 10 minutes of driving.
- After warming up remove the oil pressure detection plug and install the oil pressure gauge [SST: ST2505S001(J-34301-C)].CAUTION: When using the oil pressure gauge, be sure to use the O-ring attached to the oil pressure detection plug.
- Securely engage the parking brake so that the tires do not turn.
- Start the engine, then measure the line pressure at both idle and the stall speed.CAUTION:
- Keep the brake pedal pressed all the way down during measurement.
- When measuring the line pressure at the stall speed, refer to "INSPECTION AND JUDGMENT ".
LINE PRESSURE : Refer to "LINE PRESSURE ".
- Install the oil pressure detection plug and tighten to the specified torque after the measurements are complete. Refer to
"EXPLODED VIEW ".CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.