A/T Fluid: Changing

Warm up ATF.
Stop engine.
Drain ATF from drain plug and refill with new ATF. Always refill same volume with drained ATF.
- To replace the ATF, pour in new ATF at the A/T fluid charging pipe with the engine idling and at the same time drain the old ATF from the radiator cooler hose return side.
- When the color of the ATF coming out is about the same as the color of the new ATF, the replacement is complete. The amount of new ATF to use should be 30 to 50% increase of the stipulated amount.
  ATF : Refer to "GENERAL SPECIFICATION ".
  
  Fluid capacity : Refer to "GENERAL SPECIFICATION ".
  CAUTION:
  - Use only Genuine NISSAN Matic ATF. Do not mix with other ATF.
  - Using ATF other than Genuine NISSAN Matic ATF will cause deterioration in driveability and A/T durability, and may damage the A/T, which is not covered by the INFINITI new vehicle limited warranty.
  - When filling ATF, be careful not to scatter heat generating parts such as exhaust.
  - Do not reuse drain plug gasket.
  Drain plug - tightening torque : Refer to "EXPLODED VIEW ".
Run engine at idle speed for 5 minutes.
Check A/T fluid level and condition. Refer to "INSPECTION ". If ATF is still dirty, repeat step 2 through 5.
Install the removed A/T fluid level gauge into A/T fluid charging pipe.