Removal and Installation: Installation

WARNING: This page is about a different car, the 2008 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.

Install the new O-ring to the transfer control device.
CAUTION:
- Do not reuse O-ring.
- Apply petroleum jelly to O-ring.
Fig 1: Installing O-ring
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the transfer control device.
1. Turn the control shift rod fully counterclockwise using a flat-bladed screwdriver, and then put a mark on the control shift rod.
  
  Fig 2: Identifying Control Shift Rod Counterclockwise
  Courtesy of NISSAN MOTOR CO., U.S.A.
2. Align the transfer control device shaft cutout with the mark on the control shift rod, and install.
  NOTE: Turn the transfer control device when the transfer control device connection does not match.
  
  Fig 3: Identifying Transfer Control Device Shaft
  Courtesy of NISSAN MOTOR CO., U.S.A.
3. Tighten the bolts to the specified torque. Refer to , "DISASSEMBLY AND ASSEMBLY ".
Install the breather hose to the transfer control device.
Connect the transfer control device connector.
After the installation, check the 4WD shift indicator pattern. If NG, adjust the position between the transfer assembly and transfer control unit. Refer to , "PRECAUTION FOR TRANSFER ASSEMBLY AND TRANSFER CONTROL UNIT REPLACEMENT ".

Fig 4: Locating Transfer Control Device Bolts

Courtesy of NISSAN MOTOR CO., U.S.A.