Component Inspection (Ignition Relay)

1. Turn ignition switch OFF.
2. Remove ignition relay.
3. Check the continuity between ignition relay terminals under the following conditions.
   TERMINALS CONTINUITY REFERENCE
   
   

   Terminals	Condition	Continuity
   3 and 5	12 V direct current supply between terminals 1 and 2	Existed
   	No current supply	Not existed

   Fig 1: Checking Continuity Between Ignition Relay Terminals

   Courtesy of NISSAN MOTOR CO., U.S.A.

Is the inspection result normal? 

YES: INSPECTION END

NO: Replace Ignition relay