Commercial Service Tool

WARNING: This page is about a different car, the 2008 Infiniti QX56. However, it is still accessible from the selected car via links, so may be relevant.

COMMERCIAL SERVICE TOOL

(Kent-Moore No.) Tool name		Description
Power tool	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening bolts and nuts
Spark plug wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing spark plug
(J-24239-01) Cylinder head bolt wrench	Courtesy of NISSAN MOTOR CO., U.S.A.	Loosening and tightening cylinder head bolt, and use with angle wrench [SST: KV10112100 (BT-8653-A)] 13 (0.51) dia. 12 (0.47) 10 (0.39) Unit: mm (in)
Valve seat cutter set	Courtesy of NISSAN MOTOR CO., U.S.A.	Finishing valve seat dimensions
Pulley puller	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing crankshaft pulley
Piston ring expander	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing piston ring
Valve guide drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Removing and installing valve guide Intake & Exhaust: 9.5 mm (0.374 in) dia. 5.5 mm (0.217 in) dia.
Valve guide reamer	Courtesy of NISSAN MOTOR CO., U.S.A.	Reaming valve guide hole Reaming hole for oversize valve guide Intake & Exhaust: d1: 6.0 mm (0.236 in) dia. d2: 10.175 - 10.196 mm (0.4006 - 0.4014 in) dia.
Front oil seal drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing front oil seal
Rear oil seal drift	Courtesy of NISSAN MOTOR CO., U.S.A.	Installing rear oil seal
(J-43897-18) (J-43897-12) Oxygen sensor thread cleaner	Courtesy of NISSAN MOTOR CO., U.S.A.	Reconditioning the exhaust system threads before installing a new A/F sensor and heated oxygen sensor (Use with anti-seize lubricant shown below.) J-43897-18 (18 mm dia.) (0.71 in) for zirconia heated oxygen sensor J-43897-12 (12 mm dia.) (0.55 in) for Titania heated oxygen sensor
Anti-seize lubricant (Permatex 133AR or equivalent meeting MIL specification MIL-A-907)	Courtesy of NISSAN MOTOR CO., U.S.A.	Lubricating A/F sensors and heated oxygen sensor thread cleaning tool when reconditioning exhaust system threads