Component Inspection

CHECK THROTTLE POSITION SENSOR

Turn ignition switch OFF.
Reconnect all harness connectors disconnected.
Perform "THROTTLE VALVE CLOSED POSITION LEARNING : SPECIAL REPAIR REQUIREMENT ".
Turn ignition switch ON.
Set selector lever to D (A/T) or 1st (M/T) position.

Check the voltage between ECM harness connector and ground.

TERMINALS VOLTAGE REFERENCE

ECM		Ground	Condition		Voltage
Connector	Terminal	Ground	Condition		Voltage
F101	30 [TP sensor 1 (bank 1)] 31 [TP sensor 1 (bank 2)]	Ground	Accelerator pedal	Fully released	More than 0.36V
	30 [TP sensor 1 (bank 1)] 31 [TP sensor 1 (bank 2)]			Fully depressed	Less than 4.75V
	34 [TP sensor 2 (bank 1)] 35 [TP sensor 2 (bank 2)]			Fully released	Less than 4.75V
	34 [TP sensor 2 (bank 1)] 35 [TP sensor 2 (bank 2)]			Fully depressed	More than 0.36V

Is the inspection result normal?

YES: INSPECTION END

NO: GO TO 2.

REPLACE ELECTRIC THROTTLE CONTROL ACTUATOR
1. Replace malfunctioning electric throttle control actuator.
2. Go to "SPECIAL REPAIR REQUIREMENT ".
  INSPECTION END